MIL-T-62110G
3.10.3 Left rear controls, type II. The controls for type II vehicles shall be located at the left rear of the vehicle. An operator's platform shall be furnished. The platform shall be located at the left rear corner of the body. The platform shall isolate the operator from ground in the event of the derrick contacting an energized electrical line. The platform shall be of the folding type.
3.10.4 Controls in basket. In addition to the lower controls, controls shall be provided at the basket(s) for rotating, extending, retracting, elevating and lowering the derrick to its fullest extent. If telescopic linkage type controls between the basket(s) and the lower controls are provided, the top section of the telescopic tubes shall be spiral wound fiberglass. Design and placement of the controls shall be so as to prevent inadvertent actuation by the operator. The lower controls shall be capable of overriding the basket controls and of rendering the basket controls inoperative. When two baskets are furnished, the controls in the basket shall be within easy reach of either basket. The controls at the basket shall be located at the right or left side of the basket in a position easily accessible to the operator facing the work area. Controls on the front or rear of the basket shall not be furnished. The controls shall be identified as to their function. When two baskets are furnished, the identification plates shall be located to be seen from either basket. The identification plates shall be located at the controls and shall be readable in all positions of the extended derrick.
3.11 Outriggers. Two hydraulically operated outriggers shall be provided for size 55 and four hydraulically operated outriggers shall be provided for size 70 vehicles. The outriggers
shall enable leveling of the vehicle on inclined surfaces and shall ensure adequate stability with
relation to the ground while operating the derrick under loads and conditions specified in 3.3.3 through 3.3.8. The outrigger cylinder hydraulic fittings, hoses, tubing, and pilot check valves, when not enclosed, shall be protected by metal guards and accessible for service. The guards shall withstand being stepped on without damage to the guards, hydraulic lines, or fittings. The outriggers shall be designed so that they may be extended over curbings and sidewalks.
3.11.1 Outrigger controls. An individual control for each outrigger shall be furnished. All controls for the left outriggers shall be provided at the rear left corner of the vehicle and controls for the right outriggers shall be provided at the rear right corner of the vehicle. All outrigger controls shall be installed in a readily accessible location which permits operation from ground level. An automatic pilot check valve shall be provided for each outrigger to block the hydraulic fluid in the cylinder and to prevent movement of the outriggers in the event of a damaged hydraulic line. Interlocks shall be furnished to prevent the operation of the derrick assembly until the right and left side outriggers have descended into place on the ground surface.
38
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business