MIL-T-62110 Trucks, Maintenance: With Rotating Hydraulic Derrick, 32,000 To 44,500 Gvw, 4X2, 4X4, 6X4, And 6X6, CommercialThis specification covers maintenance trucks with a rotating and telescoping hydraulic derrick. Vehicles procured under this specification are commercial items which are warranted by the manufacturer as specified in acquisition documents.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58

MIL-T-6211OG

3.4.15  Bumper.  Unless the bumper is an integral part of the vehicle cab, or unless a front mounted winch is specified (see 3.4.22), a channel type front bumper shall be provided.

3.4.15.1  Rear end protection.  The rear end of the vehicle shall be protected in accordance with Federal Motor Carrier Safety Regulation 393.86.  A rear bumper shall be provided (see 3.5.1).

3.4.16  Tool stowage.  Stowage space of sufficient size to accommodate a vehicle jack, hand tools, antiskid chains, and emergency reflective triangles shall be furnished for retaining equipment during vehicle operation.  Stowage space for these tools may be furnished inside the cab or body cabinets.  When stowage space for these tools is located outside of the cab or body, it shall be weatherproof and shall provide for locking with a padlock.

3.4.16.1  Tools.  When specified (see 6.2), each vehicle shall be furnished with tools required for exchanging a mounted tire assembly with the spare assembly, and shall include at least a hydraulic jack, jack handle, and wheel-nut wrench.  The jack shall be of such closed height as to permit its location under the axle, or other satisfactory lift point, at any wheel with the tire flat.  The jack, without blocking, shall be capable of raising any wheel of the loaded vehicle to a height adequate to permit removal and replacement of a wheel and tire assembly.

*          3.4.17  Heater and defroster.  The vehicle shall be provided with a hot water heater with fresh air intakes and discharge outlets to the floor and to windshield defroster louvers.  The heater shall be complete with blower and mounted controls convenient to the driver.

*          3.4.18  Controls and operating mechanisms.  All controls and operating mechanisms shall be located for left-hand drive.  Controls shall be complete and conveniently operable by the driver.  Lever controls shall be designed and located to permit easy entrance and exit of the operator to and from the driver's compartment.  Instruments and controls shall be identified as to their function and installed in a manner to facilitate removal and servicing.  All instruments shall be visible to the driver when seated in the driving position.

3.4.19  Accessories and equipment.  The chassis equipment shall be complete with all accessories furnished as standard equipment by the manufacturer.  The following minimum equipment shall be furnished:

24