MIL-T-62223 Truck, Mobile Blood Donor And Component Laboratory, Tilt Cab, Diesel Or Gasoline Engine Driven, 24,000 Pounds Gvw, 4X2, CommercialThis specification covers a completely self-contained, mobile, self-propelled unit, designed to serve as a combination mobile blood component processing laboratory and three-bed donor facility. The vehicle shall be diesel or gasoline engine driven, four-wheel, two rear wheel drive, having minimum gross vehicle weight GVW of 24,000 pounds and shall be equipped with a tilt cab, a 30 kilowatt kW auxiliary generator and a 4 kW auxiliary generator. The body shall be fully air conditioned and heated. Vehicles procured under this specification are commercial items which shall be warranted by the manufacturer as specified in procurement documents.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37

MIL-T-62223B(AT)

3.7.6 Door and window installation. All exterior doors and windows shall be properly located, fitted and sealed to prevent entrance of air, dust and water. All doors and windows and associated hardware shall operate without binding. Window curtains shall be the appropriate color, durable material, free of uneven stitching, crooked seams, runs, tears or color fade and shall be installed in an orderly fashion.

3.7.7 Installation of insulation. The insulation shall be installed in a manner that will exclude excessive voids, open spaces, rips, tears and other types of damage or defects. Wherever practical, the insulation shall be installed prior to the closing of spaces in the body interior. The insulation shall be installed and secured in a manner to retain the material in a permanent

position under all operating conditions.

3.7.8 Floor installation and floor covering. Galvanized sheet metal used to enclose the floor area shall be securely installed and free of gaps, open seams, cuts or open holes. All wood parts shall be free of cracks or splinters and thoroughly treated to provide full and uniform coverage (see 3.5.4). The material shall be applied uniformly, free of thin or bare areas. The carpeting shall be installed on the floor surface and fitted without gaps, visible seams, bulges, frayed edges or color fade.

3.7.9 Electrical system installation. The electrical system installation shall provide proper routing of electrical wiring with clearances between wiring and applicable parts. All wiring shall be mechanically and electrically secured, fastened or clipped at points of bending and protected against chafing and damage. Wiring shall be concealed and easily accessible for repairs. All circuits shall be properly grounded. Electrical wire covering (insulation) shall be free of cracks, cuts, kinks, frays or similar defects. All wiring and outlets shall be securely installed to preclude loose or faulty connections. Wall outlets and electrical fixtures shall be installed uniformly. All electrical appliances shall be securely mounted and properly positioned to prevent damage.

3.7.10 Air conditioning and heating system installation. The ceiling mounted ducts shall be straight and smooth on the inside with joints neatly finished. Ducts shall be anchored

securely and shall be free of vibration and undue noise. Joints and outlet connections shall be substantially airtight. Laps shall be made in the direction of the airflow. All edges and slips

shall be smooth. Ducts shall be free of dents, nicks, buckling, open seams and deformation. The adjustable diffusers shall be securely mounted and fitted in a neat straight position. The diffusers