MIL-T-62223 Truck, Mobile Blood Donor And Component Laboratory, Tilt Cab, Diesel Or Gasoline Engine Driven, 24,000 Pounds Gvw, 4X2, CommercialThis specification covers a completely self-contained, mobile, self-propelled unit, designed to serve as a combination mobile blood component processing laboratory and three-bed donor facility. The vehicle shall be diesel or gasoline engine driven, four-wheel, two rear wheel drive, having minimum gross vehicle weight GVW of 24,000 pounds and shall be equipped with a tilt cab, a 30 kilowatt kW auxiliary generator and a 4 kW auxiliary generator. The body shall be fully air conditioned and heated. Vehicles procured under this specification are commercial items which shall be warranted by the manufacturer as specified in procurement documents.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37

MIL-T-62223B(AT)

3.5.6.4 Auxiliary generator. There shall be installed in an insulated, fireproof compartment within the body skirt at streetside an auxiliary, 120/240-volt generator of not less than 4-kW capacity. The generator engine shall be supplied from the vehicle fuel tanks

(see 3.4.3.2). Louvered access doors shall be provided. The generator shall provide electrical power to operate installed refrigerators, lights and at least one auxiliary electric heater while in transit. Auxiliary generator will relieve the cost of operation and maintenance of the 30-kW power plant when interior air conditioning and centrifuges are not being used. The auxiliary engine generator set installation, engine equipment and accessories, generator compartment, and generator accessories shall be furnished in accordance with the same requirements specified for the main engine generator in 3.5.6.3 through 3.5.6.3.3. Exhaust from the engine generator shall be directed towards the rear rather than the front for dissipation of exhaust gases during in-transit travel.

3.5.6.5 Power inlet, 120/240-volt. A weatherproof power inlet receptacle shall be provided near the rear of the vehicle to accept 150 ampere, 120/240-volt, 4-wire, single phase,

60-Hz local power. The receptacle shall be wired into the vehicle electrical system through appropriate circuit breakers/disconnects.

3.5.6.5.1 Lead-in cable. A 50-foot, neoprene-jacketed, 4-wire, lead-in cable equipped with a plug and weatherproof receptacle on one end and alligator clips on the other end shall be provided to permit 120/240-volt local power to be fed directly into the vehicle if so desired. The cable shall be sized to unit total capacity.

3.5.6.6 Power inlet, 120-volt. One 120-volt, 30-ampere, 3-wire, grounded, weatherproof inlet receptacle shall be provided on the vehicle exterior feeding a plugmold receptacle within

the body interior. Separate line shall permit the use of plug-in 120-volt equipment plus a portable nighttime heater within the body interior through use of local power sources via the

lead-in cable. A 50-foot lead-in cable, with standard plugs, shall be provided.

3.5.6.7 Exterior portable floodlights. Waterproof 120-volt receptacles shall be installed on the body exterior adjacent to the entrance door. Two brackets shall be mounted for holding floodlights for night illumination. Two 150-watt portable floodlights shall be provided. The floodlights shall be removable for storage during transit. The floodlight installation shall be protected by ground fault interrupters.