MIL-V-62347(AT)
3.8.2 Marking. Vehicle exterior markings shall be lusterless black color, number 37038 of FED-STD-595 except for safety markings, and shall conform to MIL-STD-642. Otherwise, the weapon station shall be marked in accordance with MIL-W-13855. Parts and components shall be marked in accordance with MIL-STD-130.
3.8.3 Safety markings. Unless otherwise specified (see 6.2), safety hazard plates and decals for the vehicle and component assemblies shall be posted in accordance with applicable drawings.
3.8.4 Name, shipping and service data plates. The plates shall meet the requirements of
MIL-P-5l4, or applicable drawings.
3.9 Workmanship. Workmanship shall be of a quality to assure that the vehicle and its components are free of defects that compromise, limit or reduce capability in the performance of its intended use. In addition to general appearance, the defects listed in table IV shall be considered to be cause for failure. Electric wires and hydraulic lines shall be located in a manner so as to prevent possible damage by rubbing on adjacent lines or appendages. No workmanship condition shall exist which may create a safety hazard to operating or maintenance personnel.
3.10 TOW Dismount/remount. The TOW component mounting and storing provisions shall enable a four man crew to dismount the TOW components, needed for ground deployment, within 5 minutes for emplacement within 50 meters of the vehicle. The same crew shall mount TOW components and return the vehicle to a combat ready condition within 5 minutes.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or purchase order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
4.1.1 Materials and qualified products. The contractor's records shall be reviewed to determine conformance to 3.3, 3.3.1 and 3.3.2.
4.1.2 Parts and components. Parts, components and assemblies shall be inspected for conformance to requirements of drawings subordinate to 8736977 and applicable specifications and standards (see 3.4.1, 3.4.2, and 3.4.3). When applicable, inspection shall also be in accordance with Supplementary Quality Assurance Provisions (SQAPs) or Quality Assurance Requirements (QARs).
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business