of the vehicle and shall include
identification information and
an electric control station with
any caution notice shall be on a
environmentally
sealed
standard decal or plate from the
connections, that the operator
supplier of that item. The decal
can reach easily while standing
or plate describing operation of
on the ground, or riding on the
the hydraulic tailgate shall be
platform.
Tailgate operations
provided in close proximity to
shall be hydraulically metered,
the hydraulic tailgate controls.
providing for raising, lowering,
Rear bumper and additional rear
folding and unfolding without
end protection need not be
manual assistance. The tailgate
furnished.
shall be operated hydraulically
Hydraulic tailgates must conform
through an electric driven
to FMVSS-223 and 224.
hydraulic pump. The hydraulic
HTGX
INCREASED CAPACITY FOR
system shall comply with the
HYDRAULIC LIFT GATE
requirements
in
paragraph
When code HTGX is specified,
3.1.1.10. All hydraulic cylinders
the tailgate (HTG, HTGR or
shall be provided with flow
HTGU) shall have a rated
restrictors in the down port of
capacity not less than 1350 kg
the cylinders to prevent the
(3000 lb) and meet all other
tailgate from falling rapidly in the
requirements of the specified
event of a hydraulic system
liftgate (HTG, HTGR or HTGU)
failure.
The vehicle ignition
switch or a separate switch in
HTR
HIGHWAY TRANSPORTABILITY
the driver's compartment shall
When code HTR is specified,
allow the driver to disconnect
highway
transportability
the power source to the tailgate.
requirements for class C, D, E
A
150-ampere
minimum,
and F vehicles shall include
automatic reset circuit breaker
unrestricted highway transport in
shall be furnished with the
both the Continental United
electric system of the tailgate, to
States (CONUS) and Outside
protect the electric system of the
the Continental United States
vehicle. A minimum of 2-gage
(OCONUS) in accordance with
wire shall be furnished on the
the interface criteria published in
power cables for maximum
"https://www.tea.army.mil/pubs/nr
operating
efficiency
and
/deploy/transinstruction/MIL-
increased electrical component
STD-1366D.pdf" \t "_blank", for
life. A rustproof enclosure shall
unrestricted highway transport.
be furnished to protect the pump
In addition, all vehicles with a
motor from dirt and weather.
highway
transportability
Self-lubricated bearings shall be
requirement must be equipped
furnished on all load bearing
with military standard tie down
rollers and hinges. All hydraulic
provisions as specified in MIL-
lines shall be grommeted where
STD-209 and option code TDN.
they are routed through walls
See 4.4
and supports and furnished with
clamps for protection from
LED
LIGHTS, LIGHT EMITTING
damage.
DIODES (LED)
The hydraulic tailgate operating
When code LED is specified, all
instructions, the hydraulic fluid
added stop/tail directional, and
Page 51 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business