to not less than 200 mm (8
Note: when code MPS is
inches) ground clearance. The
specified, a significant increase
hoisting
mechanism,
hoist
in the chassis GVWR may be
cylinder and hydraulic system
required. The increased GVWR
shall be capable of holding the
could change a non-CDL or a
snowplow in the fully raised
non-FET chassis to a chassis
position while the truck is driven
that requires the operator to
over secondary gravel roads at
have a CDL or to be subject to
speeds up to 48 km/h (30 mph).
FET.
Hydraulic lines to the hydraulic
MS
MUD & SNOW TIRE
cylinder and the pump shall be
When code MS is specified on
provided with quick disconnect
4x2 vehicles, mud and snow
hose couplers.
Hose caps,
tread shall be provided on rear
pump caps and hydraulic
axles.
cylinder caps shall be provided if
no other protection system is
MTL
TRAILER LIGHTING CABLE 110
provided.
Caps shall be
INCHES
secured with a corrosion-
When code MTL is specified, a
resistant security device to
trailer lighting cable conforming
prevent loss. Caps shall prevent
to SAE J1067 shall be provided.
entrance of contaminants into
The cable shall be coiled and
the hydraulic system when
shall be not less than 2800 mm
disconnected.
(110 in) long when fully
A set of raised auxiliary dual
extended. Both ends of the
beam headlights, parking, and
cable shall be equipped with a
turn signal lights shall be
round plug conforming to SAE
provided for use with the
J560.
The plugs shall be
snowplow.
Parking and turn
equipped with a grip for
signal lights shall use a single
withdrawing from the connector
light bulb. Mounts, adapters and
sockets. The cable shall be
an appropriate wiring harness
packaged and stowed in the
shall be provided.
Quick
vehicle tool compartment.
disconnect
plugs
and
receptacles shall be provided
MTR
MARINE TRANSPORTABILITY
and shall be weatherproof, or
When code MTR is specified,
shall
be
located
in
a
marine
transportability
weatherproof location. A high
requirements for class C, D, E
beam indicator light shall be
and F vehicles shall include
provided and shall be readily
unrestricted water transport by
visible to the driver when in the
all
standard
military
and
driving position.
commercial
watercraft
in
Snowplow markers shall be
accordance with the interface
provided for the street side and
criteria published in "MIL-STD-
curbside of the snowplow. The
1366 Transportability Criteria".
markers shall be removable
In addition, all vehicles must be
when not in use. The markers
equipped with military standard
shall eliminate guesswork as to
lifting and tie down provisions
position of the snowplow caused
(option LTD) as specified in MIL-
by blind spots.
STD-209 and option code LTD.
See 4.4.
Page 56 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business