marker lights shall be light
structural
elements
in
emitting diodes. LED lights shall
accordance with MIL-STD 209
be
installed
with
tamper
requirements. In cases when
resistant hardware.
the structural analysis indicates
the provisions will clearly pass
LH
LOW PROFILE CHASSIS
the
requirements,
actual
When code LH is specified, a
physical testing may not be
low profile chassis shall be
necessary.
In cases when
provided with minimum 19.5
where the structural analysis
tires and a maximum of 25 cm
indicates the provisions will
(35 in) to top of unloaded frame
marginally
pass
the
at centerline of rear axle.
requirements,
redesign
or
testing shall be recommended to
LSD
SYNTHETIC LUBE
the contractor. In cases where
DIFFERENTIAL
the structural analysis indicates
When code LSD is specified,
the provisions will clearly fail the
differentials shall be provided
requirements, a redesign of the
with
synthetic
lubricant.
provisions shall be required.
Synthetic lubricant supplied shall
A shipping data plate shall be
be approved by the component
furnished and shall conform to
manufacturer and furnished by
composition A (class 1 or 2) or
the chassis OEM.
composition C of A-A-50271.
The shipping data plate shall be
LST
LUBRICANT, SYNTHETIC FOR
inscribed
with
a
diagram
MANUAL TRANSMISSION
showing the lifting attachments
When code LST is specified, the
and lifting slings, the capacity of
manual transmission shall be
each attachment, and the
provided with synthetic lubricant.
required length and size of each
Synthetic lubricant supplied shall
sling cable. A silhouette of the
be approved by the component
vehicle showing the center of
manufacturer and furnished by
gravity shall be provided on the
the chassis OEM.
transportation plate. Stenciling
or other suitable marking shall
LTD
LIFTING AND TIEDOWN
PROVISIONS.
identify all lifting and tie down
When option code LTD or MTR
attachments.
Tie
down
is specified, the vehicle shall be
markings shall clearly indicate
equipped with four (4) lifting
that
the
attachments
are
provisions and four (4) tie down
intended for the tie down of the
provisions
to
ensure
equipment on the carrier. See
interoperability
between
4.4
transported
equipment
and
MHW
WINCH HYDRAULIC
lifting and tie down devices
When code MHW is specified, a
commonly
used
in
the
winch assembly mounted on the
transportation
environment.
front of the vehicle shall be
Lifting and tie down provisions
provided. The winch shall be
shall conform to MIL-STD-209
powered by the manufacturer's
for both Type I and Type II
standard power takeoff or
equipment. The contractor shall
powered hydraulically.
If
perform a structural analysis of
hydraulically
powered,
the
the tie down and lifting
hydraulic system shall comply
provisions and the surrounding
Page 52 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business