the center of the body. The door
wheel wells. Two-piece floors
shall be of aluminum faced
shall be spliced longitudinally
plywood or of all aluminum with
and completely welded the full
bracing to prevent sagging. The
length of the splice.
One
door shall be equipped with at
completely welded lateral steel
least three hinges. A cam type
floor splice is acceptable on
locking device shall be provided
bodies over 4880 mm (16 feet)
with an operating handle and
in length.
shall be installed to ensure
BSR
SWING, RIGHT & LEFT SIDE
positive closing under all
CENTER RACKS
operating conditions. Provisions
When code BSR is specified,
shall be incorporated for a
the center racks on both sides
padlock.
Handles shall be
shall be the manufacturer's
located to permit operation from
standard swing type, for easy
ground level.
The hardware
side loading.
shall
be
manufacturer's
standard. The door shall have a
BTB
TARPAULIN, BOWS/TIES
weather tight rubber or plastic
When code BTB is specified, a
seal around the perimeter. The
fitted tarpaulin with knockdown
body shall be equipped with
type bows and tiedown devices
devices to hold door in a fully
shall be provided. The tarpaulin
open position. Side doors on
shall be fabricated of number 8
refrigerated
van
shall
be
cotton duck conforming to Type I
insulated and sealed as required
of CCC-C-419, or of vinyl-coated
for designated classification.
nylon conforming to Type II,
Class 2 of MIL-PRF-20696. The
BSF
SMOOTH STEEL FLOOR
tarpaulin material shall be
When BSF is specified, smooth
reinforced at the corners and
steel floors, one or two-piece,
other wear points with patches
3.2 mm (1/8 in) thick, shall be
fabricated of the same base
provided for the body with
material as the tarpaulin. The
additional
lateral
support
tarpaulin material shall be water
provided at the wheel wells.
repellent and fire-resistant. The
Two-piece floors shall be spliced
tarpaulin color shall be olive
longitudinally and completely
drab. The rear curtain shall be
welded the full length of the
of the roll-up type. The front
splice. One completely welded
curtain shall have a window size
lateral steel floor splice is
of not less than 300 mm by 610
acceptable on bodies over 4880
mm (12 in by 24 in) and shall be
mm (16 feet) in length. When
aligned with the rear window of
specified diamond tread (code
the vehicle cab. The tarpaulin
BDF2) or smooth (code BSF2)
shall completely cover the entire
steel floor shall be minimum 5
body and shall extend down the
mm (3/16 in) thick.
sides, front and rear, with the
bows in place, to within 75 mm
BSF2
HEAVY DUTY SMOOTH FLOOR
(three inches) of the platform.
When BSF2 is specified, the
Bows shall be on the outside of
body floor shall be smooth steel,
the racks and shall be
with a minimum thickness of 5
constructed of metal or metal
mm (3/16 in) and additional
and hardwood components. At
lateral support provided at the
Page 41 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business