rating shall be furnished in the
3.5.3.3.1 and 3.5.3.5 through
load space as follows:
3.5.3.5.2 for the class furnished,
a) One centered at the front of
except that the cargo body shall
the load space
be 12 feet, 6 inches long by 8
b) Four at the outboard edge of
feet wide (nominal). The load
each side, equally spaced, the
space shall be minimum 147
length of the load space.
inches in length and 88 inches in
Lashing D rings shall be
width. Sides and ends shall be
furnished at the exterior of each
24 inches high (minimum) with 5
top rail, mid way between the
stake pockets on 35 inch.
front and the rear of the body.
centers furnished on each side.
Mountings and D rings shall be
Sides and ends shall be
capable of withstanding pulls of
minimum 12 gauge steel. Floor
3,000 pounds in any direction
shall be minimum 8 gage
without permanent deformation.
diamond tread plate.
Drain
When D rings are positioned in
holes shall be provided in the
the raised position, there shall
front corners. The front panel
be adequate clearance above
shall be capable of withstanding
the top rail to attach a 2-inch
a horizontal static load equal to
hook.
half the payload capacity of the
vehicle
without
permanent
BDD
DOUBLE REAR DOORS
distortion. The cargo body shall
When code BDD is specified,
be adequately reinforced to
double rear doors shall be
provide support for an evenly
provided for a van body, full
distributed payload (GVW minus
width and height, with bracing to
curb weight and driver weight).
prevent sagging, and equipped
A minimum of 10 crossmembers
with three cast steel, or equal,
shall
be
furnished.
hinges per door.
The door
Crossmembers
shall
be
locking devices shall include not
minimum 10 gauge and shall be
less than three bolts or latches,
gusseted on each long sill. The
located at top, bottom and
tailgate shall be hinged at the
center of the door. Cam type
bottom and provided with
locking
devices
may
be
removable
stay-chains
of
furnished at the top and bottom
adequate length to retain the
of the door. The center locking
tailgate in a horizontal position.
device shall be provided with an
Two (2) steps shall be furnished
operating handle and shall be
on each the left and right sides
installed to ensure positive
of the tailgate to assist
closing under all operating
personnel in mounting and
conditions. Provisions for the
dismounting.
The rear lights
use of a padlock shall be
and reflectors shall be recessed
furnished. The van body shall
in the rear bolster and shall be
be equipped at the sides with
positioned to prevent damage by
catches for holding the doors in
the lowering of the tailgate.
the
fully
open
position.
Grab handles shall be furnished
Hardware
shall
be
the
at the rear of the body on both
manufacturer's standard. Rear
sides. Cargo tie downs, fully
doors shall conform to TMC RP
recessed, with 3 inch inside
711.
diameter and a 2000 pound load
Page 38 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business