BR
TRANSLUCENT ROOF
Class F vehicles. Conversion
When code BR is specified, the
hoist ratings shall be in
van body roof panel over the
accordance with the National
cargo
section
shall
be
Truck Equipment Association
translucent white, fiberglass
Conversion Hoist Chart. The
reinforced, polyester material,
hoist shall be a double-acting
minimum 1.8 mm (.070 in).
scissors or under body type with
an internal bypass system.
BRT
INTERIOR ROPE TIES
Hoist hydraulic cylinder piston
When code BRT is specified,
rods shall be chrome plated.
interior rope ties, fold-down
The hoist shall lift the body to a
lashing rings, rope cleats, or rod
minimum dumping angle of 45
type, shall be installed and
degrees measured from the top
secured to wall frame members
of the truck chassis frame. The
of the van body. When code
hoist shall be capable of
FRP is specified, interior rope
lowering the raised body by
ties using through fasteners with
gravity when the pump is
a head diameter of not less than
disabled. The controls shall be
13 mm (0.50 inch) shall be
located in the truck cab and
provided. FRP/plywood fastener
shall be accessible to the seated
installation
shall
be
driver.
The location of the
waterproofed
and
exposed
controls shall not interfere with
fasteners shall be painted to
the entry and exit of the driver.
match the vehicle exterior. A
Hydraulic system and pumping
minimum of 36 rope ties shall be
unit shall comply with 3.1.1.10.
arranged in three evenly spaced
A mechanical safety lock,
tiers, four rope ties per tier on
permanently affixed to the body,
each wall, including the front
shall be furnished. The safety
wall.
The first tier shall be
lock shall provide positive
located just above the scuff
retention of the body in the up
plate, the second tier at 1/3 of
position for servicing or repair.
the wall height, and the third tier
The safety lock mechanism shall
at 2/3 of the wall height. Rope
not interfere with the operation
ties shall project not more than
of the body under any operating
9.5 mm (0.375 inch) into the
conditions.
cargo area beyond the wall
lining. Rope tie protrusions shall
BFA
FLOOR, ALUMINUM TYPE
be rounded and constructed to
When code BFA is specified, a
prevent injury to personnel and
diamond tread aluminum plate
snagging of payload inside the
floor, 3.2 mm (1/8 inch) thick
cargo area. Note: Code BRT is
and an underlay laminated
not available when code CRT is
hardwood of not less than 29
specified.
mm (1-1/8 inch) thick, shall be
provided for a van body. Wood
BSD
DOOR, CURBSIDE
parts shall be treated in
When code BSD is specified,
accordance with 3.1.1.3. Wood
curbside swing door, not less
floorboards shall be attached to
than 178 cm (70 in.) high and
the subframe at crossmembers
not less than 76 cm (30 in.) wide
with self-tapping, countersunk,
shall be provided on a van body.
corrosion-resistant screws.
The door shall be located near
Page 40 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business