MIL-T-62032H
3.5.23.1 Speed ends. Each fuel servicing system shall be furnished with two speed ends equipped with 2.5 inch, camlock, quick couplings and elbows, and each shall be 36 inches long. One speed end shall have a tubing size of 2.375 inch outside diameter (od) and one shall have a tubing size of 1.875 inch od. In addition, each fuel servicing system for type III and IV vehicles shall include a speed end with a tubing size of one inch. All tubing shall be nonsparking.
3.5.24 Electrostatic discharge protection. Electrostatic discharge protection, equivalent to paragraph 4-3.2 of NFPA No. 407, shall be provided. Bonding straps shall be provided between the tank, all plumbing, and the vehicle chassis (see 3.1.1.5). Brass static lugs shall be provided at the side of the manhole. When a filler/separator is furnished, provisions shall be made to dissipate electrostatic electrical charges generated in the product fuel during filtration. A charge relaxation chamber providing a charge relaxation time (fuel-to-metal contact) of not less than 30 seconds shall be provided, downstream of the filter/separator and upstream of the hose reel. (See API RP 2003).
3.5.24.1 Ground cable reel. A ground cable reel shall be installed in a location that will permit easy withdrawal and recovery of the grounding wire. The cable reel shall contain a ratchet for retaining the ground cable in any extended position so that tension is not maintained on the ground cable. The reel shall have an outlet guide. The reel shall be furnished with a grounding cable approximately 80 feet long, plus "Y" ends 20 feet long. The "Y" ends shall be equipped with clamp connectors for electrically connecting the truck to ground and the truck to the unit being serviced. The clamp connectors shall conform to MIL-C-83413, part number M83413. The cable shall be No. 12 stranded copper, or 0.094 inch diameter 7x7 stainless or galvanized steel. The cable shall be covered with petroleum-resistant rubber or nylon. The free
end of the cable shall be provided with an elastomeric bumper (ball). The ground cable reel shall be located in the underslung cabinet. Ground cable reel mounting surfaces shall be free of paint and contamination, and shall be securely mounted to the cabinet so as to prevent the cable reel assembly from being pulled away from its mountings. A warning plate shall be attached to the cable reel, stating: "WALK BACK GROUNDING CABLE TO REEL."
3.5.25 Identification and instruction plates. Identification, instruction, schematic diagram and chart-type plates shall be permanently attached and located so as to be accessible and visible to the operator. All plates shall conform to composition A (class 1 or 2) or composition C of MIL-P-514. The plates shall be securely installed with corrosion-resistant metal fasteners. Plates shall be masked prior to painting. All valves, switches, levers, controls and other devices used in the operation of the fuel servicing system shall be properly identified
by identification plates. The identification and instruction plates shall incorporate a numerical or
34
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business