contain cracks, dents or have
YD54
DIESEL ENGINE 210 HP, 605
voids.
LB/FT
When YD54 is specified, an
5. ... Misalignment of body fasteners,
electronically
controlled
glass, viewing panels, light
turbocharged
diesel
engine
housings, other items with large
producing minimum gross ratings of
or uneven gaps, spacing etc.
210 HP and 605 Lb./Ft/ of torque
such as door, body panels and
shall be furnished.
hinged panels.
3.7
WORKMANSHIP.
6. ... Improperly
fabricated
and
A.
Vehicles shall be free from defects,
routed wiring or harnesses, and
which may impair their serviceability
electrical connections.
or detract from appearance.
7. ... Improperly
supported
or
B. All bodies, systems, equipment and
secured
hoses,
wiring
interfaces with the chassis shall be
harnesses, mechanical controls
done in accordance with the OEM's
etc., including interference with
Body Builders Book.
Whenever
other components.
dissimilar metals are used they shall
8. ... Interference
of
chassis
be insulated against corrosive action.
components, body parts, doors
C. All components will be new.
etc.
Defective components shall not be
9. ... Leaks of any gas, vacuum, or
furnished.
Parts, equipment and
fluid lines (air conditioning,
assemblies which have been repaired
coolant, oil, oxygen, etc.).
or modified to overcome deficiencies
10. . Noise, panel vibrations etc.
shall not be furnished without the
approval
of
the
purchaser.
11. . Inappropriate or incorrect use of
Component parts and units shall be
hardware,
fasteners,
manufactured to definite standard
components, or methods of
dimensions
with
proper
fits,
construction.
clearances and uniformity. Welded,
12. . Incomplete or improper welding,
bolted, and rivet construction utilized
riveting or bolting.
shall be in accordance with the
13. . Lack
of
uniformity
and
highest
standards
of
industry.
symmetry where applicable.
General appearance of the vehicle
shall not show any evidence of poor
14. . Loose, vibrating abrading body
workmanship.
parts,
components,
subassemblies, hoses, wiring
D. The following shall be reason for
harnesses or trim.
rejection:
15. . Improper body design or
1. ... Rough, sharp or unfinished
interface with the chassis that
edges, burrs, seams, corners,
could cause injury during
and joints.
normal use or maintenance,
2. ... Nonuniform panels. Edges that
and which fail to provide access
are not rounded, beveled, etc.
to perform routine or mandatory
3. ... Paint runs, sags, orange peel,
repairs or maintenance on
"fish eyes" etc., and any other
vehicle
electrical
and
imperfection or lack of complete
mechanical systems.
In
coverage of paints or coatings.
addition,
the
improper
combination of options which by
4. ... Body panels or components
their
combination
and
that are uneven, unsealed, or
Page 72 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business