MIL-T-740G
3.4.15 Dump truck. With the hydraulic system filled with engine oil of the type and grade specified in table IV, for the applicable temperature, and adjustment completed, vehicle(s) shall demonstrate performance requirements with loads specified herein during dumping operations. The hydraulic system controls shall control and actuate the system to raise and lower the dump body, and hold body in any position during the raising and lowering range of operation. The controls shall operate without binding, interference, or failure, using hand effort only.
3.4.16 Drop side cargo body. The drop sides and tailgate shall raise, and lower freely, without binding. The locking devices shall retain the sides and tailgate rigidly in closed position without chatter or failure, using hand effort only. The drop sides shall be interchangeable from left to right sides and from right to left.
3.4.17 Air transportability. All vehicles, except the M246A1, M246A2, M543A1, M543A2, M291Al, M291A2, M291A2C, M291A2D, M816, M819, M820, M820Al and M820A2 models shall be air transportable in phase II of airborne operations -without disassembly. The M246A1, M246A2, M543A1, M543A2, M291Al, M291AID, M291A2, M291A2C, M291A2D, M816, M819, M820, M820A1, and M820A2 models shall be capable of air transportability in phase III airborne operations without disassembly. The M291A1, M291AID, M291A2, M291A2C, M291A2D, M820, M820Al and M820A2 models shall be capable of air transportability in
phase II airborne operations by removal of body from chassis.
3.4.18 Radio-interference suppression. Each vehicle shall be radio-interference suppressed in accordance with the tactical vehicle requirements of MIL-STD-461.
3.5 Painting, marking, and data plates.
3.5.1 Painting. The vehicle, body(s) and components shall be cleaned, treated, and painted in accordance with MIL-STD-193, as specified for the appropriate service (see 6.2). Painted surfaces shall be free of sags, runs, and thin areas.
3.5.2 Marking. Vehicle marking shall be in accordance with MIL-STD-642, as specified for the appropriate service (see 6.2).
3.5.3 Data plates. Data plates shall conform to type III, composition A, class 2 of
MIL-P-514.
3.5.3.1 Data plates (bolster and stake trucks). The bolster truck, M748Al, M748A2, M815 and truck, stake, bridge transporting, M328A2 wo/w, M328A2 w/w, M328A1 w/w, and
M821 w/winch, shall have permanently located instruction warning and caution plates describing any special procedure to be followed in operation, loading and servicing of the specified body.
3.6 Rustproofing. When specified (see 6.2), vehicles shall be rustproofed in accordance with
MIL-R-0046164.
3.7 Wood treatment. All wood parts shall be cleaned and treated in accordance with the requirements of MIL-STD-193.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business