MIL-T-62320 Trucks, Van: Shop, Diesel And Gasoline Engine Driven, 19,000 Pounds Gvw, 4X2 And 4X4, CommercialThis specification covers diesel and gasoline engine driven, four-wheel, two-rear-wheel drive, and four-wheel, four-wheel drive, shop van trucks having a minimum gross vehicle weight GVW of 19,000 pounds for normal operating conditions. Vehicles procured under this specification are commercial items which are warranted by the manufacturer as specified in acquisition documents.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32

MIL-T-62320C

* 3.4.12.1 Cab interior. Unless otherwise specified, the cab shall have an upholstered, full width, adjustable seat and back or individual, adjustable, driver's seat and individual passenger seat. When specified (see 6.2), an individual, adjustable, driver's seat and an individual passenger seat shall be provided. When specified (see 6.2), the driver's seat shall be the manufacturer's standard air ride suspension type. The color of the upholstery and the interior finish shall be compatible with the exterior color (see 3.1.1.1). White upholstery shall not be provided. Interior lighting shall be provided. Two pairs of seat belts shall be installed.

3.4.12.2 Crew cab. When specified (see 6.2), a four-door full width crew cab shall be furnished in lieu of the standard, full width cab. The cab shall be equipped with two upholstered, full width seats and backs. The front seat shall be adjustable. Fastenings and three pairs of seat belts shall be installed for both front and rear seats. Cab doors shall be equipped with locks operable from inside the cab through mechanical linkage, with both front doors equipped with external key operated lock. Cab doors shall have windows with crank operated window regulators. Interior lighting shall be provided. The cab roof shall be of-one piece construction; or, if welded, the roof shall give the appearance of one piece with weld seams being continuous, waterproof, and free of visible seams, bumps, or protrusions. Full length drip moldings shall be mounted above the doors. When a crew cab is furnished, the cab-to-axle dimension shall be measured from the back face of the crew cab.

3.4.12.2.1 Crew cab seat. spacing. With the front seat adjusted to the extreme forward position, there shall be not less than 30 inches, measured in a horizontal plane, between the front of the rear seat back and the rear of the front seat back. A kick-space height of not less than

2-3/4 inches shall be maintained between the floor and the rear of the front seat in all positions of adjustment. Leg room and space forward of the front seat shall be equivalent to that provided ahead of the seat in a two-door standard cab.

3.4.13 Steering. Power steering shall be furnished.

3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual windshield wipers and windshield washers. The windshield wipers shall be of the multispeed type, operated by either air or electric motor(s).

3.4.15 Bumper. Unless the bumper is an integral part of the vehicle cab, a channel type front bumper shall be provided except when a front mounted winch is furnished (see 3.4.22).

3.4.15.1 Rear end protection. The rear end of the vehicle shall be protected in accordance with Federal Motor Carrier Safety Regulation 393.86. A rear bumper shall be provided as specified herein.