3.4.11.3 ANTILOCK BRAKE SYSTEM.
interior finish shall be compatible with the
Vehicles equipped with air brakes shall be
exterior color (see 3.1.1.1).
White
provided with an antilock brake system in
upholstery shall not be furnished. Interior
accordance with FMVSS 571.121.
lighting shall be provided. Three sets of
Vehicles equipped with hydraulic brakes,
seat belts shall be installed on bench
shall be provided with an antilock brake
seats.
Outboard seats shall have
system in accordance with FMVSS
combination pelvic and upper torso
571.105. Type II tractors shall have the
restraint seat belts. A rear cab window
SAE J560 seven-pin connector wired to
shall be furnished, unless a sleeper
conform to TMC RP 137.
compartment is specified.
3.4.12
CAB.
3.4.13
STEERING.
Unless otherwise specified, an OEM
Power steering shall be furnished.
conventional type full width cab shall be
3.4.14
WINDSHIELD
provided. Unless otherwise specified, a
The vehicle shall be equipped with dual
cab with a forward tilting hood and fender
windshield
wipers
and
windshield
assembly, including tilting and locking
washers. Windshield wipers shall be of
mechanism, shall be provided. Tilting
the multi-speed intermittent type and
shall
not
interfere
with
installed
operated by electric motor(s).
equipment. Both cab doors shall be
equipped with locks, operable from inside
3.4.15
BUMPER.
the cab through mechanical linkages and
Unless the bumper is an integral part of
equipped with external, key operated
vehicle cab, a channel type front bumper
locks. Drip protection shall be provided
shall be provided on each vehicle.
above the cab doors. Safety grips or grab
handles shall be provided on each side of
3.4.15.1 REAR END PROTECTION.
the cab to assist personnel in entering
Except for Type I chassis, Type II tractors,
and leaving the cab and, in addition, for
and Type IV dumps, the rear end of the
Type II tractors, to assist personnel in
vehicle shall be protected in accordance
climbing onto the truck tractor deck plate.
with Federal Motor Carried Safety
When step height into the cab exceeds
Regulation 393.86. A rear bumper shall
610 mm (24 inches) a secondary step
be provided as specified herein for the
shall be provided, in accordance with
various vehicle types.
TMC RP 404B. When a snowplow or
snowplow provisions are specified,
3.4.16
TOOL STOWAGE.
service hatches or access or butterfly type
Stowage space of sufficient size to
hood shall be furnished to provide access
accommodate a vehicle jack, hand tools,
for routine engine maintenance with a
anti-skid chains (for outside tires on duals
snowplow attached. Cab equipment shall
only) and emergency reflective triangles
include: a 12-volt electrical power point
shall be provided. The stowage space
outlet (receptacle), easily accessible to
shall provide for positive retention of this
the seated driver; and tinted glass in all
equipment during vehicle operation.
windows, where optionally available from
Stowage space for these tools may be
the chassis manufacturer.
furnished in the cab. When stowage
space for these tools is located outside
3.4.12.1 CAB INTERIOR.
the cab, it shall be weatherproof and shall
Unless otherwise specified, the cab shall
provide for locking with a padlock or
have an upholstered, full width, adjustable
integral lock.
seat and back or individual, adjustable,
driver's seat and individual passenger
seat. The color of the upholstery and the
Page 20 of 79
to verify that this 7 4Y
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business